Operating Instructions

Box contains:
1 completer water sensor
4 mounting screws
Strip of two-sided tape
1 CR123A 3V lithium battery
SPECIFICATIONS:
PART NUMBER:WS900
BATTERY: CR123A (REPLACEABLE)
RF FREQUENCY 900MHz
OPERATING HUMIDITY: 0-90%
OPERATING TEMPATURE 32F (0 C) – 120F (49C )
DIMENSIONS: 3.5” X 1” X.85”
WEIGHT: 1.76 oz
FCC statement
This device complies with FCC rules part 15 operation is subject to the following two conditions
This device may not cause harmful interference. This device must accept any interference received including
interference that may cause undesired operation
FCC caution
The user that changes or makes modifications not expressly approved by the party responsible for compliance
could void the users authority to operate this equipment
FCC Compliance Statement Statements This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device
must accept any interference received, including interference that may cause undesired operation. FCC
Warning (Part 15.21). Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. FCC Interference Statement (Part 15.105
(b)). This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.