User Manual

04
Check NVR Network , Change NVR system login
password
2
Once you have completed connecting the NVR, wait approximately 2-3 minutes. Next
you will see the window below on your monitor screen. Password is NOT required, click
OK to continue.
Right click on the home screen of your monitor, navigate to Main Menu > Network.
Select DHCP Enable as shown in the figure below and click ok. Then click Netservice
to check if the Cloud status shows connected. If it shows Probing DNS,Check if you
connect your NVR with router well. Connect the Router LAN Port to NVR WAN Port
with Network Cable Provided. Then select DHCP Enable again and Power off NVR
around 2-3 seconds then power on, wait 2-3 minutes to double check.
If above solutions are not working, please e-mail to [e-mail]