Installation Guide

20
Sandstone Window and Door Trim (WDT) can be used as a universal trim piece to
terminate sections of NextStone™ where the panels will not turn a corner and/or as a
trim piece around windows and doors. For most applications, Sandstone Window and
Door Trim must be installed prior to the panels.
When using the WDT as a termination piece for a
wainscot application:
Step 1
Measure the total height of the wall before the Ledger
attachment to determine length/height of WDT needed.
Step 2
Use a level when placing WDT. Screw at a 45° angle
through the top of the piece and down along the inside
edge making sure to attach securely to the underlying
substrate. To miter for use with ledger, cut the top of
the piece on a 15°angle, with the long side of the angle
against the wall. (Shown below #1)
Step 4
If desired, a wood rasp can be used to round edges of
the door/window trim to provide a more realistic look.
Touch-up paint can be applied to the area formed with
the rasp. Always use a finished end to start and
terminate a section of door window trim. Cut ends can be butted tight and
concealed with touch-up paint and caulk. (Shown below #2) End Ledger with a
factory finished end. (See ledger installation).
TRIM INSTALLATION
Window and Door
Trim under the
Ledger
SANDSTONE WINDOW AND DOOR TRIM
1. 2.