Installation Guide

26
Top Course with Screw Hem Attached
Adhesive
Points
Bottom of Cap (fig. 1)
Bottom of Cap (fig. 2)
Adhesive
Points
Top Course with Screw Hem Removed
The Sandstone 18" Column Wrap Cap is designed to fit the Slatestone 30"
Column Wraps or Columns made with Interlocking Outside Corners.
Screw Attachment:
Drive one screw per side at an angle through the bottom lip of the cap all the way
into the substrate. Do not over angle the screws so they don’t run through the top
of the cap. Do not overdrive screws.
Adhesive Attachments:
Step 1
If the top course ends with the screw hem attached: Place adhesive in each corner
of the cap and secure. (fig. 1).
2) If the top course ends with the screw hems cut off, face screw each piece 1”
from the top so that the cap covers the screw heads. Place adhesive on inside
cutouts of cap as shown (fig. 2).
COLUMN WRAP INSTALLATION
SANDSTONE COLUMN WRAP CAPS