Installation Guide

Step 1

Attach the cap by applying adhesive around the top surface of

the post. (fig. 1)

Step 2

Apply adhesive on the inside of the Post

Cap along the inside ledge. (fig. 2)

Use 3” screw

Step 2

Using 3" deck screws minimum, attach the mount to the post

screwing through the Post and into the landing. (fig. 5)

Note:

Finish the job using NextStone™ Textured Grout and Touch Up

Paint to cover any space around the mountings and to hide all

screw heads .

(fig. 5)

(fig. 4) (fig. 3) (fig. 2) (fig. 1)

(Fig. 2)

(Fig. 8)

(fig. 1)

SLATESTONE POST COVER

INSTALLATION

SLATESTONE POST COVER CAP

Step 1

After locating the desired height of the railing and securely attaching the mounts,

(see note on previous page), measure up on the outside of the post cover and select

the spot to place the landing. In this example, Trex ™ universal mounts are used.

When the landing location is selected, dry fit the landing on the rock surface. Using

a carpenter knife or chisel, cut out the high points of the rock surface to achieve a

smooth and flat surface. (fig. 1-4)

Installing Rail Mounts

Rail Mounts must be purchased separately. NextStone™ does not manufacture Rail Mounts.

(fig. 2)