Installation Guide

3
Compared to natural or cast stone, NextStone™ polyurethane products are designed
for an easier, quicker installation requiring fewer steps. Masonry skills are not
required. This Manual provides basic guidelines for NextStone™ installation.
Additionally, it is recommended that Installers review applicable building codes for
specific products and/or geographic areas. This publication is not intended to
provide specific advice, legal or otherwise, on particular products or processes.
Readers should consult with their own legal and technical advisors, suppliers, and
other appropriate sources including but not limited to product or package labels,
technical bulletins and sales literature that contain information about known health
and safety risks. NextStone™ does not assume any responsibility for the users
non-compliance of applicable laws and regulations.
This Installation Manual should be used as a guide for installation of NextStone™
Products. It is the responsibility of the Contractor and/or the Installer to ensure
panels are installed in accordance with these instructions and any applicable building
codes. The manufacturer assumes no liability for either improper installation or
personal injury resulting from improper use or installation.
ACCLIMATION
All products must be allowed to acclimate for a minimum of 48 hours. While
Polyurethane expands and contracts in it’s natural state, heat and moisture may
cause minimal expansion and contraction. Best results are obtained by installing
cool, dry product. NextStone™ does not warrant against gapping caused by
expansion and contraction.
STORAGE AND TRANSPORTATION
All panels must be stored flat, in the box, at 65° Fahrenheit when possible until
ready for installation. While polyurethane has minimal expansion and contraction,
the effects of expansion and contraction can be minimized by avoiding installation
during periods of extreme heat or cold. Do not store in direct sunlight before
installing.
INSTALLATION BASICS
Never leave cut edges of NextStone™ products exposed. Exposed Polyurethane will
discolor with exposure to sunlight. Use NextStone™ touch-up paint or other color
match with a good quality latex paint. Drive the first screw on the right hand side of
the panel at a 45 degree angle to the left in order to tighten the panel into adjacent
panel, corner or wall.
IMPORTANT NOTES
FORWARD