Installation Guide

SANDSTONE INSIDE CORNERS

Step 1

Determine how you plan to finish the corner as this will dictate the length of the corner.

Corners can be capped with ledger or ledger corners. For a ledger finish, the top of the

corner (the end with the lip on top) should be 1 ⅝" below the top of the flange on the top

panel.

Step 2

Locate corner so that the bottom of the corner will be flush with the bottom of the

bottom panel. Screw thru the recessed channel at the top, bottom and middle of each

side of the corner using at least a 4 ½" screw. Adhesive maybe applied to the blocks on

the back side of the corner, if appropriate for the installation.

Step 3

If more than one length of outside corner is required, stack the corners by locking the

male end at the top of the corner to the female end on the bottom of the corner.

CORNER INSTALLATION