Installation Guide

SLATESTONE OUTSIDE CORNER

Step 1

Metal Starter Strip - Determine at what height above grade level you

want the panel to sit. Measure up 2 ¾" from this point and strike a level

line. Attach the top of the starter strip on this line. End the strip 2"

from each side of the corner.

Step 2

Set the Slatestone outside corner piece against the corner and down

into the starter strip. Use the screw guides and place at least 3

screws along the tongue. Place 2 screws in the right lap side of the

panel where indicated.

Step 3

Attach the panels working out from each side of the corner as

previously described.

Note: There are 4 patterns of the Slatestone Outside Corner.

2 Left patterns and 2 right patterns. Check for numbers on the

backside of the piece. They are numbered 1 through 4. Alternate

left and right corners with each course to prevent pattern repetition.

CORNER INSTALLATION

All products must be allowed to acclimate; r emoved fr om boxes and stored flat at the

installation site for a minimum of 48 hours or until properly acclimated prior to installation. Heat

and moisture cause expansion. Best results are obtained by installing a cool, dry product.

NextStone™ does not warrant against gapping caused by expansion and contraction or

improper installation.