Installation Guide

NEW CONSTRUCTION

Step 1

All studs must be straight and true to avoid bulges or dips in the finished wall. Correct

any bowed studs prior to installation if necessary.

Step 2

All sheathing must be properly fastened to the framing according to building code

requirements and/or the sheathing manufacturer’s recommendations. NextStone™

should be applied over a sheathing that provides a smooth, flat, solid, non-expansive,

stable surface. Consult local building codes for additional sheathing requirements.

Step 3

Sub wall assembly must be weather tight before applying NextStone™. NextStone™

accessories alone may not constitute a waterproof installation. Wall sheathing should be

weather-resistant, or covered with a weather-resistant barrier such as fanfold

insulation, housewrap, or building paper. Independent studies indicate that the

combination of a weather resistant barrier plus a house wrap results in improved

weather performance. Some building code jur isdictions are cur r ently r equiring

this protection. A weather-resistant covering should be properly fastened according to

the manufacturer’s instructions, and be smooth and even. Flashing and caulking should

be added as needed in such areas that transition from NextStone™ ledgers to other

siding products, windows, and doors to control moisture and protect the sub wall

assembly.

EXISTING STRUCTURES

Step 1

Secure or remove any loose siding material and replace any rotten wood. Scrape off

loose caulk and other build-up that may interfere with the NextStone™ installation.

Remove all items such as downspouts, light fixtures, vents. etc. in the area to be

covered.

Step 2

Install suitable sheathing, as needed, to provide a smooth, flat, and stable surface for the

installation of NextStone™ panels. See information in step 3 of the New Construction

section for additional instructions on sub wall protection and flashing.

PREPARING THE WALLS