Installation Guide

CORNER INSTALLATION

SANDSTONE OUTSIDE CORNERS

Determine how you plan to finish the corner as this will dictate the length of the

corner when using bold Sandstone Outside Corners versus Interlocking Corners.

Corners can be capped with ledger or ledger corners.

Step 1

Cut 6 pieces of plumbers strap approximately

6" long. With the corner upside-down so that

the “stair-step” blocks are exposed, attach

the strap to the top block on the left side so

that it extends out at a right angle to the

corner. The same should be done to the 3

block, the bottom block, and finally to the

same three blocks on the right side.

Step 2

Apply the corner so that the bottom of the

corner lines up with the bottom of the first

panel. Screw through the end of the strap into the structure.

Step 3

If more than one length of outside corner is required, stack the corners by locking

the male end at the top of the corner to the female end on the bottom of the

corner.

Note: Sandstone

Accessories are

universal and can

be used with all

panel profiles

Optional Install:

Corners can be face

screwed to attach but

must be filled in with

grout and painted over

to conceal screw

heads.