Installation Guide

SANDSTONE INSIDE CORNERS

Determine how you plan to finish the corner as this will dictate the length of the

corner. Corners can be capped with ledger or ledger corners. For a ledger finish, the

top of the corner (the end with the lip on top) should be 1 ⅝" below the top of the

flange on the top panel.

Step 1

Place corner so that the bottom of the corner will be flush with the bottom of the

bottom panel. Screw thru the recessed channel at the top, bottom and middle of

each side of the corner using at least a 4 ½" screw. Adhesive maybe applied to the

blocks on the back side of the corner, if appropriate for the installation.

Step 2

If more than one length of outside corner is required, stack the corners by locking

the male end at the top of the corner to the female end on the bottom of the

corner.

CORNER INSTALLATION

Note: Sandstone Accessories are universal and can be used

with all panel profiles

Optional Install:

Corners can be face

screwed to attach but

must be filled in with

grout and painted over

to conceal screw

heads.