Installation Guide

16
CORNER INSTALLATION
INTERLOCKING OUTSIDE CORNERS
Step 1
After placing the Start Strip, set the outside corner piece
against the corner and down into the strip. Using the screw
guides, place at least 3 screws along the top tongue and 2
screws at the right lap side of the corner where indicated.
(fig. 1)
Step 3
Interlock the panels working out from each corner. (fig. 3)
Install from Left to Right.
 If the length of the wall does not allow the panels to
interlock into the corners at the end of a run, cut the panel
vertically in the middle of the panel to meet the length.
 If terminating the run at the right side with alternate trim
pieces, measure the end of the grout line to the accessory
piece and add 1" if sliding behind a trim piece. Straight cut
the panel and fit behind trim piece or cut the panel flush so
it meets the terminating Accessory.
Step 2
Slide the second corner over the top of the first corner and
attach as indicated above. Continue alternating corners until
desired height is reached. (fig. 2)
Figure 1
Figure 2
Figure 3
All products must be allowed to acclimate; removed from boxes and stored at the
installation site for a minimum of 48 hours. Heat and moisture cause expansion. Best
results are obtained by installing a cool, dry product. NextStone™ does not warrant
against gapping caused by expansion or contraction due to improper installation.