Installation Guide

17
CORNER INSTALLATION
INTERLOCKING OUTSIDE CORNERS CONTINUED
Figure 2
Note: Interlocking Outside Corners come Four (4) Corners per box (2 Left, 2 Right).
Corners are all different patterns. Check for the numbers on the inside of each
corner and be sure to alternate left and right corners with each course preventing
possible pattern repetition.
Figure 3
Step 4
Corners can be capped with a Sandstone Ledger (requires miter cutting) or
Sandstone Ledger Outside Corner. (fig. 4)
All products must be allowed to acclimate; removed from boxes and stored at the
installation site for a minimum of 48 hours. Heat and moisture cause expansion. Best
results are obtained by installing a cool, dry product. NextStone™ does not warrant
against gapping caused by expansion or contraction due to improper installation.
Step 5
Cut panels and corners around fixtures and other wall protrusions (hose bibs,
electrical boxes, dryer vents, etc.) to accommodate NextStone™ Mounting Blocks.
See Install instructions on page 23 for details on how to install the mounting blocks.
Figure 4