Installation Guide

22
TRIM INSTALLATION
SANDSTONE LEDGER OUTSIDE AND INSIDE CORNERS
Outside and Inside Ledger Corners can be used for a faster, miter free installation.
Theses pieces are molded for 90˚ angles.
Simply place the Ledger Inside or Outside Corner over the top of the corner using the
“v” groove. If the corners have been cut for height, use the bottom surface of the
Ledger Corner. Toe screw as with the Ledger.
Note:
If the Ledger is used to go over the top of an outside or inside
corner accessory, a compound miter is required. This can be
achieved using a chop saw or radial arm saw. Place the ledger
on the saw table with the back of the ledger flush against the
fence (just the way it sits when applied), and make a 45° miter
cut. The corner will then require caulking and NextStone™
touch-up paint.