Installation Guide

CORNER INSTALLATION

All products must be allowed to acclimate; removed fr om boxes and stored flat at the

installation site for a minimum of 48 hours or until properly acclimated prior to installation.

Heat and moisture cause expansion. Best results are obtained by installing a cool, dry

product. NextStone™ does not warrant against gapping caused by expansion and contraction

or improper installation.

Step 1

Metal Starter Strip - Determine at what height above grade level

you want the panel to sit on. Measure up 2 ¾" from this point and

strike a level line. Attach the top of the starter strip on this line.

End the strip 2" from each side of the corner.

Step 2-Set the Stacked Stone outside corner piece against the

corner and down into the starter strip. Use the screw guides

and place at least 3 screws along the tongue. Place 2 screws

in the right lap side of the panel where indicated. (Fig. 7).

Figure 7

Step 3-Attach the panels working out from each side

of the corner as previously described. (Fig. 8)

Figure 8

Note: There ar e 4 patter ns of the Stacked Stone Outside

Corner. 2 Left patterns and 2 right patterns. Check for

numbers on the backside of each corner piece. They are

numbered 1 through 4. Alternate left and right corners with

each course to ensure offsets and to prevent pattern

repetition.

STACKED STONE OUTSIDE CORNER