Installation Guide

59
Component: acgih tlv (units) Osha pel (units)
Processing Waste 5 mg / cubic meter (8 hour twa) 5 mg / cubic meter (8 hour twa)
Processing Waste 10 mg / cubic meter (stel) 10 mg / cubic meter (stel)
Section 5: REACTIVITY DATA:
Stability: Stable under normal conditions
Incompatibility
(Materials to avoid): Avoid open flame. Avoid contact with oxidizing agents. Product may auto-
ignite at temperatures in excess of 450 degrees Fahrenheit.
Hazardous decomposition products: Thermal and / or thermal oxidative decomposition can produce irritation and
toxic fumes and gasses including carbon monoxide, hydrogen cyanide
Section 6: HEALTH HAZARD DATA:
Rigid polyurethane is not considered or listed as a hazardous chemical in 29 CFR 1910 subpart Z, Product Safety Act (15
U.S.C. 2051), or the Federal Hazardous substances Act (15 U.S.C. 1261)
Foam dust may be a by-product of the installation process.
Ingestion: Not applicable
Eye Contact: Eye irritation possible
Skin Contact: Waste generated from processing may evoke allergic contact dermatitis in
sensitized individuals.
EMERGENCY AND FIRST AID PROCEDURES:
Eye Contact: Immediately flush with copious amounts of water. Remove to fresh air. If irritation persists, get medical
attention.
Skin Contact: Wash affected area with soap and water. If rash or persistent irritation or dermatitis occurs seek medical
attention.
Inhalation: Remove to fresh air. If persistent irritation, severe coughing or breathing difficulty occurs, seek medical
attention.
Ingestion: Not applicable
Section 7: TOXICITY DATA:
Processing Dust: May cause nasal dryness, irritation and obstructions, coughing, wheezing, and sneezing. Sinusitis and
prolonged colds have also been reported. Depending on the type, processing dust may cause respiratory
sensitization and or irritation.
Section 8: PROTECTION INFORMATION AND CONTROL MEASURES:
Respiratory protection: Dust mask, if dust exceeds allowable exposure limits wear a NIOSH / OSHA
approved respirator.
Eye protection: Safety glasses or goggles
Skin protection: None required (gloves optional)
Engineering Controls: Provide adequate general and local exhaust ventilation to most exposures.
Section 8: PRECAUTIONS FOR SAFE HANDLING AND USE:
Release / Spill Handling: Scrap material or dust from sawing or cutting should be handled as an inert
solid, in the fashion of sand.
Waste Disposal Method: Landfill as non-hazardous waste.
Storage: Panels and accessories should be stored in original boxes to prevent damage
or deformation of the product.
Important: The information and data herein are believed to be accurate and have been
compiled from sources believed to be reliable. It is offered for your
consideration, investigation and verification. Buyer assumes all risk of use,
storage and handling of the product in compliance with applicable federal,
state and local laws and regulations. NextStone makes no warranty of any
kind, express or implied, concerning the accuracy or completeness of the
information and data herein. The implied warranties of merchantability and
fitness for a particular purpose are specifically excluded. NextStone will not
be liable for claims relating to any party’s use of or reliance on information
and data contained herein regardless of whether it is claimed that the
information and data are inaccurate, incomplete or otherwise misleading.