Installation Guide
COUNTRY LEDGESTONE OUTSIDE CORNER
Step 1
Metal Starter Strip - Determine at what height above grade level you want
the panel to sit on. Measure up 2 ¾" from this point and strike a level line.
Aach the top of the starter strip on this line. End the strip 2" from each side
of the corner. (Fig. 1)
Step 2
Set the Ledgestone outside corner piece against the
corner and down against the starter strip. Use the screw
guides and place at least 3 screws along the tongue.
(Fig. 2)
Place 2 screws in the right lap side of the panel where
indicated. (Fig. 3)
When making mulple courses, alternate the corners
le and right to give proper oset and stagger to joints.
(Fig. 4)
Step 3
Aach the panels working out from each side of the
corner as previously described. (Fig. 5)
Note: There are 4 paerns of the Ledgestone Outside Corner. 2 Le paerns and 2 right paerns.
Check for numbers on the backside of the piece. They are numbered 1 through 4. Alternate le and
COUNTRY LEDGESTONE CORNER INSTALLATION
All products must be allowed to acclimate; removed from boxes and stored at at the
installaon site for a minimum of 48 hours or unl properly acclimated prior to
installaon. Heat and moisture cause expansion. Best results are obtained by installing
cool, dry product. NextStone does not warrant against gapping caused by expansion
and contracon.
Manufacturer does not warrant against gapping caused by
expansion and contracon.
To validate warranty, product MUST be registered. Register this product at:
WWW.StoneSidingWarranty.com
Fig. 1
Fig. 3
Fig. 4
Fig. 5
Fig. 2
Screw Points