Instructions / Assembly

36
SLATESTONE 2PC POST COVER INSTALL
1) Post covers are 41” tall. Measure up 41” on the post. Cut the post to
this height. (Fig. 1)
2) When using a 4 x 4 post, either fir out the post to
5 ½ x 5 ½ or use the optional Converter Kit Rings.
4 pieces per kit.
(Fig. 2)
3) Place the bottom ring (marked B), flange down, onto the deck.
Predrilled the four sides and attach the ring to the post using 2” galva-
nized screws. Use shims to make the ring snug and centered on post.
(Fig. 3)
4) Measure up 13 ½” and 27 ½ “ from the deck. Use a Speed
Square to mark a line around the post at these heights. Slide the
2 rings (marked M) so the bottom of the ring is on these lines,
shim and screw in place as described above. (Fig. 4)
If attaching railings, the following must be done PRIOR to the
placement and attachment of the post.
Measure up and mark on the post to the height of the bottom and
top rail. Fir out the post on these faces at these heights an additional 1".
These will act as the landings for the rail mounts. Use a 3"x3" x1" block.
Center the block at the scribed line . ( Fig. 5)
Consult local codes for height requirements of rails.
5) Position Side 1, with the arrow facing up. Seat the bottom of the post
into the bottom ring. Face screw the post cover through the rings and into the
wood post using 3" galvanized screws. Screw through the post in a grout
line or at the base of a rock. This will make it easier to hide the screws.
Measure up 14" and 28" and face screw through the posts and into the rings.
The posts are designed with a grout line at these heights. (Fig. 6)
6) Place the top ring and seat into the top of the post. Shim to make the
post plumb. Screw through the indented areas into the post. (Fig. 7)
7) After securing Side 1 in place, move Side 2 into place.
Make sure the arrow is facing up.
Dry fit the piece to make sure all “T” joints line
up and are tight.
Secure side 2 at the ring heights described above.
(Fig. 2)
(Fig. 1)
(Fig. 3)
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 8)
(Fig. 7)