Installation Guide

TRIM - LEDGER, Cont.

Step 5

If the ledger is used to go over the top of outside or inside corner

accessories a compound miter is required. (Ledger Inside and Outside

Corners can be used and do not require mitering). This can be achieved

using a chop saw or radial arm saw. Place the ledger on the saw table

with the back of the ledger flush against the fence (just the way it sits

when applied), and make a 45° miter cut. The corner will then require

caulking and NextStone touch-up paint.

INSTALL LEDGER ON CUT PANEL (ALTERNATE

INSTALLATION METHOD)

If the top panel must be cut horizontally and the tongue is

removed, the ledger is installed using the flat portion on the

bottom of the ledger. The ledger is then glued to the wall behind it

and screwed using the methods described above.

SANDSTONE LEDGER OUTSIDE AND INSIDE

CORNERS

Outside and Inside Ledger Corners can be used for a faster, miter free installation.

Theses pieces are molded for 90˚ angles.

Simply place the Ledger Inside or Outside Corner over the top of the corner, using the

“v” groove. If the corners have been cut for height, use the bottom surface of the Ledger

Corner.

¼" Bead

Adhesive:

= Full Panel

= Cut Panel