Instruction Manual

6. If the bars go down, it means the air pressure has dropped and the weather is expected to get worse
from the present time “0h”.
Remarks : moving your weather from one floor of a building to another floor will affect the accuracy of
your weather station, which should operate at the same altitude all the time. If you move it to a new
location, it will take 12-24 hours to get stable and accurate again.
Our weather station provides next 12-24 hours weather forecast. It may not match with the current
weather condition outside.
TO READ MAXIMUM-MINUMUM INDOOR-OUTDOOR TEMPERATURES
Simply press the MAX-MIN button to view the maximum indoor and outdoor temperatures and
humidities with “MAX” icons appearing on the display . Press again to view the minimum indoor and
outdoor temperatures and humidities with “MIN” icons appearing on the display.
When the maximums or minimums are displayed, press and hold the MAX-MIN button to reset both
records to “---“ and it will start to record the maximums and minimums again.
IF YOU LOSE THE OUTDOOR TEMPERATURE AND HUMIDITY
When the outdoor temperature and humidity digits show '---", the wireless transmission is either
interrupted or lost. Press the OUT TEMP button on the clock once. If you continue to lose the outdoor
temperature display, try placing the transmitter in a different location until you have smooth
transmission of temperature data.
TROUBLESHOOTING
In case your weather station clock shows irrelevant information or digits, it maybe affected by
electrostatic discharge or interferences from other devices. Press the RESET button on the top right of
your unit. Your unit will be reset to default settings and it will start to receive outdoor temperature and
humidity and then WWVB signal again.
Problem Solution
LCD is blank 1. Press RESET on the main unit
2. Check if AC/DC adaptor or DC jack is loose or unplugged
No Outdoor Temperature and
Humidity is displayed
1. Press OUT TEMP on the weather station once
2. Press OUT TEMP once, then press RESET on the outdoor
sensor
3. Observe if the Low Battery icon appears on the left of the
outdoor temperature. If yes, replace batteries in outdoor
sensor with fresh alkaline batteries
4. No other interfering sources are being used (such as
computer monitors, TV sets, headphones, or speakers) in the
path of signal from the outdoor sensor. The signal travels in a
straight line, an electrical source near that “line” may cause
interference
Temperature, humidity, or air
pressure is incorrect
1. Press RESET on the main unit
2. Make sure your main unit and the outdoor sensor is away
from sources of heat / cold / direct sunshine
WWVB time and date will not set
or update
1. Wait until overnight for signal to be received
2. Move your weather station away from sources of electricity
3. Place your weather station in window facing Colorado
Time is one or few hours off 1. Make sure you select the right U.S. time zone
2. Make sure you select DST Off if you live in an area where
Daylight Saving Time does not apply (part of Arizona and
Indiana)