User Manual

through periodic and thorough evaluation of scientific studies. The standards include a

substantial safety margin designed to assure the safety of all persons, regardless of age and

health. The exposure standard for wireless mobile phones employs a unit of measurement

known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. *

Tests for SAR are conducted with the phone transmitting at its highest certified power level in

all tested frequency bands. Although the SAR is determined at the highest certified power level,

the actual SAR level of the phone while operating can be well below the maximum value. This is

because the phone is designed to operate at multiple power levels so as to use only the power

required to reach the network. In general, the closer you are to a wireless base station antenna,

the lower the power output. Before a phone model is available for sale to the public, it must be

tested and certified to the FCC that it does not exceed the limit established by the government

adopted requirement for safe exposure. The tests are performed in positions and locations

(e.g., at the ear and worn on the body) as required by the FCC for each model. The highest SAR

value for this model phone when tested for use at the head is 0.411W/Kg and when worn on

the body, as described in this user guide, is 0.903W/Kg (Body-worn measurements differ

among phone models, depending upon available accessories and FCC requirements). The

maximum scaled SAR in hotspot mode is 0.903W/Kg. While there may be differences

between the SAR levels of various phones and at various positions, they all meet the

government requirement for safe exposure. The FCC has granted an Equipment Authorization

for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF

exposure guidelines. SAR information on this model phone is on file with the FCC and can be

found under the Display Grant section of http://www.fcc.gov/ oet/fccid after searching on

FCC ID: YSEGO778 Additional information on Specific Absorption Rates (SAR) can be

found on the Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at

http://www.wow-com.com. * In the United States and Canada, the SAR limit for mobile phones

used by the public is 1.6watts/kg (W/kg) averaged over one gram of tissue. The standard

incorporates a sub-stantial margin of safety to give additional protection for the public and to

account for any variations in measurements.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure

requirements, a minimum separation distance of 10mm must be maintained between the user’s

body and the handset, including the antenna. Third-party belt-clips, holsters, and similar

accessories used by this device should not contain any metallic components. Body-worn

accessories that do not meet these requirements may not comply with RF exposure

requirements and should be avoided. Use only the supplied or an approved antenna.