Install Instructions

Step 3: Pass all AV, Integration, and Power Cables for

Projector and E-500 Lift System through Cable Outlet inside

the terminal.

Note: If you purchased the lift with the CSI Kit, make sure to

manage the cable for Contact Closure or the IR Receiver as

well.

Step 4: Cinch the cables within the terminal using the Cable

Strap. Do not completely fix the cables in place. Slack will be

need to manage the cables further in a later step.

Note: Leave about 2 ft of cable length inside the Actuation

System to allow for further cable management.

Step 5: Re-attach the Left Cable Terminal Cover by sliding the back end in first, pushing the front end down, then using

both of the Phillips Screws to fasten it into place.

Note: You may need to gently pull on the Dust Cover to completely seat the Terminal Cover