Install Instructions

Step 8: Locate the Control Panel at the front of the system

then, using a 3mm T-Handle or Allen Key, remove both of the

Control Panel Screws to lower and expose the Wired Backup

Switch.

Step 9: Using the Wired Backup Switch, run Crossmember

into the DOWN position.

Important Note: At this point, if you are using IR or Contact

Closure, disconnect Backup Switch and connect IR Receiver

or Contact Closure Integration Cable in its place.

Ensure the Universal Remote being used for Control System

is useable at this point, since it will be used to operate the

system remotely in a later step.

Step 10: Raise the Control Panel back into place then, using a

3mm T-Handle or Allen Key, fasten both of the Control Panel

Screws.

DOWN