Install Instructions

Step 13: Press and slide the Shoulder Bolts, located on the Top of the Mounting Assembly, in to the Keyed Holes of the

Crossmember inside of the Actuation System. Reference the Arrows in the image below for the direction.

Important Note: Slowly remove pressure on the Projector to ensure the Mounting Assembly is within the keyed holes.

Once the Mounting Assembly is in place, do not bump or move it until the next step is complete.

Step 14: Using the (4) Pre-Installed 3mm Hex Screws located on the Adjustment Bracket, fasten the Mounting Assembly

to Crossmember. Again do not bump or move the Mounting Assembly until this step is complete.

Note: Use the provided 3mm T-Handle to ensure the screw heads do not strip.