Install Instructions

Projector Adjustment

Step: Run the system down to expose the projector.

Step 22: Adjust Roll, Pitch, and Yaw for Projector

by placing a 3mm T-Handle or 3mm Allen Bit

through the slotted holes on the underside of the

Carrier Shroud.

Note: Roll is to the Right, Pitch is in the Center, and

Yaw is to the Left. You may also remove the Carrier

Shroud to gain more access to the adjustments.

Step 23: Re-attach the Interface Plate by

sliding the Metal Tabs of the Interface Plate

into the Slotted Holes on the Carrier Shroud,

and pressing the Interface Pins into the

Latches on the Carrier Shroud.