Assembly Instructions

Assembling the Center Actuation System

For these steps, you will need the following parts:

 Center Riser Bracket

 (1) Lift Column (Labeled C)

 Center Cable Track Bracket

 Bayonet Bracket

 (8) 6mm x 20mm FHMS

 (4) 5 x 12mm FHMS Screws

 Small Hex Key and 5mm Hex Key

 Rubber Mallet (Not Included)

Step 12: Slide the Bayonet Bracket into the welded metal sleeves of the Center Lift

Column C. Using a rubber mallet, tap the Bayonet Bracket into the welded metal

sleeves until they are flush with the top of the metal sleeve on the Lift Columns.

Step 13: Attach the Center Lift Column C to the Center Riser

Bracket using (4) 6 x 20mm FHMS Screws.

Step 14: Attach the Center Cable Track Bracket to the back of the Center Riser Bracket using (2) 6 x 16mm

BHMS Screws and (2) ¼” Flat Washers. Now seat the pigtail grommet for the Center Lift Column C so that it is

facing the back panel of the enclosure.

Note: The Center Cable Track Bracket should look identical to the photo. (Color Changed for reference).

The Center Actuation System is now assembled and ready to be installed.