Assembly Instructions

16
Step 26: Take the Motor Cable connected to port 2 and connect it to the
Upper Left Lift Column’s pigtail.
Step 27: Take the Motor Cable connected to port 3, fish it through the Lower Cable Management Track, and
connect it to the Center Lift Column’s pigtail.
You have successfully connected and managed the Lift Systems cabling.
Re-Calibrate & Re-synchronizing the Lift System
After the Motor Cables are routed and re-connected to each column you will need to reinitialize them again.
Step 28: Fully retract the lift by pressing the button without the raised dot
on the Wired Backup Switch.
Note: The Lift may be in “Safe Mode” which means you will need to keep
the button without the raised dot on the Wired Backup Switch held until
the lift fully retracts.
Once the lift is fully retracted, press and hold the button without the
raised dot on the Wired Backup Switch for 10 seconds. You should see a
slight movement from the lift system but do not release the button until
10 seconds have elapsed.
Note: If you do not see the movement on the first attempt, release the
down button and try this step again. It may take 2 or 3 tries.
You have successfully re-synchronized and reinitialized the lift system.