Assembly Instructions

Preparing the TV & Adjustments

For these steps, you will need the following parts:

 Lower Cable Track Bracket

 Vertical Mounting Bars

 Front Cover

 Lid Plate

 (5) 6 x 12mm BHMS Screws

 (4) 6 x 12mm FHMS Screws

 TV Mounting Hardware

Before you mount the TV to the Lift System you will need to know more about adjustability of the lift.

There are 2 points of adjustment on the L-75i; The Top Support Brackets, which can be adjust up and

down in ½” increments up to a total of 8” and the Screen Back Plate which can also be adjusted up or

down depending on the mounting pattern of your TV.

Step 32: Attach the Vertical Mounting Bars to the TV using the

screws found in the bag labeled “TV Mounting Screws

Hardware.” The length and size of the screw required will

depend on whether the TV has a flat/unobstructed or

irregular/obstructed back.

Flat/Unobstructed Back

Diagram “A” installation procedure:

1) Place the flat screen TV face down on a

protected surface.

2) Position the Vertical Mounting Bars

equidistant from the bottom and top of

the TV, with the slots facing toward

the top of the TV.

3) Using the four (4) Square Multi-Mount

washers and the TV mounting screws selected

from the bag, attach and tighten the hardware.

DO NOT OVERTIGTHEN HARDWARE. DAMAGE TO TV MAY RESULT.