Assembly Instructions

Please follow this procedure if you would like to limit the distance that your TV Lift extends.

To set your Travel Limit with IR Controls:

If you want the lift system to always go to its full extension, do NOT use the Height Limit Insert. Simply leave it unplugged and the system

will always travel to the full extension. To limit the travel, follow the procedure below:

1. Using the IR Receiver, run the lift system to the

ideal height limit position and stop it there.

2. With the lift system stopped, plug the Height

Limit Insert into the available RJ45 port on the

Control Box. This will set the height limit at this

position for both the IR Remote (or 3

party

universal remote) and the IR Receiver.

3. If the height limit is set at the incorrect position,

remove the Height Limit insert and repeat the

procedure.

To set your Travel Limit with RF Controls:

If you want the lift system to always go to its full extension, do NOT use the Height Limit Insert. Simply leave it unplugged and the system will

always travel to the full extension. To limit the travel, follow the procedure below:

1. Using the Wired Backup Switch, run the

lift system to the ideal height limit position

and stop it there.

2. With the lift system stopped, plug the

Height Limit Insert into the available RJ45

port on the RF Receiver. This will set the

height limit at this position for both the RF

Remote and Backup Switch.

3. If the height limit is set at the incorrect

position, remove the Height Limit insert and

repeat the procedure.