Installation Guide

13
17
16
Assembling the Actuation System
For these steps you will need the following parts:
 Lower Actuation Assembly with Lower Support
Bracket already installed in the Cabinet.
 Upper Actuation Assembly
 (8) 6 x 20 mm FHMS Screws
 Small Hex Key
Step 16: Place the Upper Actuation Assembly onto the Lower Actuation
Assembly. You may need to support the Upper Actuation Assembly until you
fasten it to the Lower Actuation Assembly. See photo to the right for reference.
Step 17: Fasten the Upper Actuation Assembly to the Lower Actuation Assembly using (8)
6 x 20 FHMS Screws. See photo to the left for reference.
Step 18: The Actuation System is now assembled.
18