Installation Guide

14
20
Assembling the Cable Management System
For these steps you will need the following parts:
 Long Cable Management Track
 Short Cable Management Track
 Screen Support
 Actuation System
 (8) 5 x 12 mm FHMS Screws
 4.5m Motor Cable
 (4) 6 x 16 mm FHMS Screws
 Small Hex Key
 3 mm Hex Key
 2 Wire Clips
Step 19: Place 1 wire clip on the inner slotted wall of the Screen
Support so that it is horizontally aligned with the 1
st
hole from
the top. Place 1 more wire clip on the same inner wall so that it
is horizontally aligned with the 5
th
hole down from the top. See
photo to the left for reference.
Step 20: Attach the Short Cable Management Track to the
Screen Support using (2) 5 x 12 mm FHMS Screws. See photo to
the right for reference.
19