Installation Guide

16
24
25
26
Step 24: Fasten the loose end of the Short Cable Management Track to the Actuation
Assembly using (2) 5 x 12mm FHMS Screws. See photo the left for reference.
Step 25: If there is excess cable below the Screen Support remove it by feeding it up into
the Short Cable Management Track and pulling it through the other side. Note: Make
sure the motor cable is not hanging in front of the Upper Column as this may trigger
collision detection when operating the lift.
Step 26: Fasten the Long Cable Management Track to the Upper Actuation Assembly
using (2) 5 x 12 mm FHMS. See photo to the left for reference.