Installation Guide

22
******IMPORTANT*****
Step 35: Once you have connected the controls, test the Lift Column as follows:
1. First, you need to “initialize” the Lift System. If you have already raised the Lift Column, lower it again,
since this step must be performed in the “down” position.
2. Find the Wired Backup Switch, which has two triangle-shaped buttons - an UP (with raised dot) and a
DOWN.
3. Press the DOWN button and HOLD IT DOWN for approximately 5 seconds.
4. You should see a slight movement in the Lift Column. If you do not see the movement, release the
Down button, and repeat the process - press and hold the Down button again for 5 seconds.
5. Once you have seen the slight movement, the Lift System is now functional.
6. Test it by pressing the Up button (no need to hold the Up button) and the lift will go up. You may let it
go to the top, or stop it at any time by pressing the Down button.