User's Manual

Globehopper Crossmodal 3.0 - User Manual

5.4 Installation Instructions

It is not permitted to perform an installation of the Globehopper Crossmodal device inside a hazardous area. If the

installation of the Nexxiot device is performed outside of a Hazardous area, then there are no special safety

considerations or precautions required.

Before the device is mounted at the desired location, make sure the following conditions are met:

• Make sure, drilling holes in the chosen mounting location does not weaken the mechanical structure of

the wagon. In case of uncertainties, get in touch with the manufacturer of the wagon to define appropriate

mounting locations

• Make sure, drilling holes in the chosen mounting location does not puncture the wagons cargo holding

area in an unwanted area. Special care must be taken for any kind of tank wagons and bulk goods wagons

• Make sure, drilling does not puncture any electrical, hydraulic or air tubes or lines or functionally vital

installations on the wagon. Such installations can be installed intentionally on the rear side of structural

beams to protect them against damage

Wear the necessary personal safety gear during the whole installation to avoid any injuries.

5.5 Maintenance Instructions

While the operation of this device is maintenance free, it is the responsibility of the customer to ensure

maintenance operations according to IEC 60079-17. It is not possible to replace the battery.

5.6 Cleaning

For best performance, please clean the solar panel on every service interval of your asset. The cleaning of

Globehopper Crossmodal device can be performed both inside and outside of a hazardous area.

To avoid scratching the solar panel and degrading its performance, it is recommended to wash the device with a

sponge or cloth, using water and soap, suitable for Polycarbonate surfaces.

5.7 Device replacement Instructions

Remove the old device from your asset by counterboring the rivets and using the App to initiate the unpairing

process. Then, install the new device to your asset and use the Smartphone App to connect the new device to

your asset.

5.8 Decommissioning an Old Device

Devices taken out of service must be sent back to Nexxiot AG. Please consult our website for the shipping

address. Nexxiot AG will take care of proper recycling.