User Manual

Nexxt Solutions - Outdoor Wireless IP Camera
7
Plug the LAN cable into the RJ-45 connector
on the end of the cable attached to the rear of
the camera.
1.
2.Plug the other end into an available RJ-45 port
on your router.
3. Connect the power cable to the wall outlet.
Please note that if you are using the camera on
a wireless network, you will need to configure the
camera for wired use, prior to configuring wire-
less settings in the device (later described in this
manual).
Accessing the IP camera
Using the IP Super Client Software
Note: The IP network camera is designed to work in
a local area network (LAN) or over the internet. For
the first method, we highly recommend using the
software included in the CD. The installation steps
are described below.