User's Manual

Nexxt Solutions - NetGate Wireless Access Point

Enter the appropriate MAC Address into the MAC Address ﬁeld. The format of the MAC

Address is XX-XX-XX-XX-XX-XX (X is any hexadecimal digit). For example: 00-0A-EB-B0-00-0B.

Enter a short description of the wireless station in the Description ﬁeld. For example:

Wireless station A.

Privilege - Select the privileges for this entry, either Allow or Deny.

Status - Select Enabled or Disabled as the status for this entry, from the Status pull-down list.

Click the Save button to conﬁrm this entry.

Click the Modify button next to the entry you want to change. If you want to erase the entry,

click on the Delete in this step.

Proceed with the changes you want to make.

Click the Save button.

Click the Enable button to enable this function.

Select the radio button: Deny the stations not speciﬁed by any enabled entries in the list to

access for Filtering Rules.

Delete all or disable all entries, if there are any entries already.

Click the Add New... button and enter the MAC address 00-0A-EB-00-07-BE in the MAC

Address ﬁeld, enter wireless station A in the Description ﬁeld, select Allow in the Privilege

pull-down list and select Enabled in the Status pull-down list. Click the Save and the Return

button at the end.

Click the Add New... button and enter the MAC address 00-0A-EB-00-07-5F in the MAC

Address ﬁeld, enter wireless station B in the Description ﬁeld, select Deny in the Privilege

pull-down list and select Enabled in the Status pull-down list. Click the Save and the Return

button to complete this procedure.

The ﬁltering rules just conﬁgured should look similar to the following list:

If you select the radio button Allow the stations not speciﬁed by any enabled entries in the

list to access for Filtering Rules, the wireless station B will still not be able to access the

router, however, other wireless stations that are not in the list will be able to access the router.

If you enable the function and select the Deny the stations not speciﬁed by any enabled

entries in the list to access for Filtering Rules, and there are not any enabled entries in the

list, thus, no wireless stations can access the router.

To add additional entries, repeat steps 1-5.

To modify or delete an existing entry:

Click the Enable All button to activate all entries enabled.

Click the Disabled All button to cancel all entries disabled.

Click the Delete All button to erase all entries.

Click the Next button to go to the following page and click the Previous button to return to the

previous page.

For example: If you want to grant access to wireless station A with MAC address 00-0A-EB-

00- 07-BE, but deny access to wireless station B with MAC address 00-0A-EB- 00-07-5F, while

all other wireless stations cannot access the router, you should conﬁgure the Wireless MAC

Address Filtering list by following these steps:

Note: