User's Manual

Nexxt Solutions - NetGate Wireless Access Point
8
2.1 LED
Chapter 2
Device layout
The AELPLDR4U1 access point features LED indicators, designed to display the connection
status and the strength of the wireless signal.
Figure 2-1 Front Panel sketch
Table 2-1
Note:
Wireless Signal Strength Indicators:
In AP or Bridge mode, all the four LEDs will light up.
In Client or Repeater mode, the corresponding LED(s) will light up when the RSSI value
(wireless signal strength value) reaches the RSSI threshold. The value of RSSI threshold
can be set on the Wireless Advanced Settings page, as shown in Figure 4-26.
For example, if the RSSI value you set is 30, while RSSI threshold of the four LEDs are 15,
25, 35, 45 respectively, then the LEDs having RSSI thresholds of 15 and 25 will light up.
Wireless Signal StrengthPower LAN
Name
Power
LAN
Status Indication
Wireless
Signal
Strength
Off No power
On Power on
Off
There is no remote wireless signal
Client or
Repeater mode
On
Indicates the wireless signal strength
of a remote AP
Off There is no device linked to the corresponding port
There is an active device linked to the corresponding port
On
Blinking
There is a device linked to the corresponding port but
no activity is being detected
•
•