User's Manual

Nexxt Solutions - NetGate Wireless Access Point
67
Note:
If either User or Password is incorrect, only a basic test will be performed. In other words, none
of the advanced options you set will take effect.
Note:
If both Duration and Data amount are specified, the test will stop after any of them is met.
Be sure to click the Run Test button to start a new test after you filled enough information.
You can also stop a running test by clicking the Stop Test button at any time.
Destination IP - The Remote device’s IP address.
User - Administrator password of the remote device. It should be filled correctly if you want
to get a precise reading. Otherwise, leave this field blank.
Advanced options - This command is used to display the advanced test options, when the
precise reading is being selected.
Duration - Use this box to specify how long the test should last.
Data amount - The maximum data amount to be sent out during the whole test.
transmit - Estimates the outgoing throughput (TX).
receive - Estimates the ingoing throughput (RX).
both - Estimates the incoming throughput (Rx) first, followed by the outgoing (Tx) throughput.
Direction - There are 3 options available for the traffic direction while estimating the throughput
•
•
•
•
•
•
•
•
•
Figure 4-63 Speed Test