User's Manual

Nexxt Solutions - NetGate Wireless Access Point
48
LAN Port - Enter a LAN Port or a range of LAN ports in this field. For example, 1030 2000.
Leave the field blank if you want all LAN ports to be used.
WAN IP Address - Enter a WAN IP Address or a range of WAN IP Addresses in this field, in
dotted-decimal notation format. For example, 61.145.238.6 - 61.145.238.47. Leave the
field blank if you want all WAN IP Addresses to be used.
WAN Port - Enter a WAN Port or a range of WAN Ports in this field. For example, 25 110.
Leave the field blank if you want all WAN to be used.
Protocol - Select the protocol to be used, either TCP, UDP, or All (all protocols supported by
the router).
Action - Select either Allow or Deny through the router.
Status - Select Enabled or Disabled for this entry from the Status pull-down list.
Click the Modify next the entry you want to change. If you want to erase the entry, click the
Delete button.
Proceed with the changes you want to make.
Click the Save button.
Click the Save button to confirm this entry.
To add another entry, repeat steps 1-9.
When finished, click the Back button.
To modify or delete an existing entry:
Click the Enable All button to activate all entries.
Click the Disabled All button to cancel all entries.
Click the Delete All button to erase all entries.
You can change the entry’s order as desired. Fore entries are before hind entries. Enter the
ID number in the first box you want to move and another ID number in second box you want to
move to, and then click the Move button to change the entry’s order.
Click the Next button to move to the following page and click the Previous button to return to
the last page.
For example: If you wish to block e-mail received and sent by the IP Address 192.168.0.7
on your local network, and to make the PC with IP Address 192.168.0.8 unable to visit the
website of IP Address 202.96.134.12, while imposing no limitations on other PC(s), you should
specify the following IP address filtering list:
3.
4.
5.
6.
7.
8.
1.
2.
3.