User's Manual

Nexxt Solutions – Wireless-N 3G router
19
Figure 3-5
Note: The router will reboot automatically after you click the Save button.
Note: WPS function is disabled by default. To do the below steps, you must enable
this option.
Follow the same steps 3G Router mode, Wireless router mode and Standard AP mode
This section will guide you on how to add a new wireless device quickly to an existing network
using the WPS (Wi-Fi Protected Setup) function.
Open the WPS menu. The following screen (shown in Figure 3-7) will appear.
If the wireless adapter supports Wi-Fi Protected Setup (WPS), you can establish a wireless
connection between the wireless adapter and the router using either the Push Button Con-
figuration (PBC) method or the PIN method.
To add a new device:
3.4 PC configuration
3.5 WPS
Go to Start Control Panel Network and Internet Network and Sharing Center
Change adapter settings. Right click on Wireless Network Connection, and select
Properties.
a.
a.
WPS Status – Enables or disables the WPS function.
Current PIN - The current PIN of the Router is displayed on this screen. The default PIN of
the Router can be found in the label or User Guide.
Restore PIN - Restores the PIN of the Router to its default value.
Gen New PIN - Click this button to obtain a new random value as the router’s PIN. You can
better protect your network by generating a new PIN.
Disable PIN of this device - WPS external registrar of entering the device’s PIN can be dis-
abled or enabled manually. If the device receives multiple failed attempts to authenticate an
external Registrar, this function will be disabled automatically.
Add device - You can add a new device to the existing network manually by clicking
this button.
•
•
•
•
•
•