User's Manual

IP CAMERA User Manual
6
3.2 Interface of Equipment
Figure 2
1） Audio Output Socket: Audio output socket is for line-out audio player, such as
headphone, speaker, etc.
2） RJ45 Ethernet Socket: RJ45 Ethernet socket is 10/100M self-adjust. The
equipment can connect to all kinds of network equipments, such as hub, router,
switch, etc.
NOTE: Factory setting IP is 192.168.0.178, the http port is 80, the username is
admin, the password is 123456.
3） WIFI Antenna Hole: Install the WIFI antenna.
4） Alarm Output Socket: The alarm output socket is connected with a relay in the IP
camera. IP camera will control the switch to trigger the alarm bell or buzzer to alarm.
The relay is able to control the switch of a alarm whose voltage is no more than 36V,
and current is lower than 2A. Please refer to the Figure 3 for the connection of an
external alarm.
Figure 3
5） Alarming Input Pin: Please refer to the schematic Diagram of Figure 4 for how
external detector collects alarm information.
The detector should be switched type (always on or always off). If the detector has
detected the smoke or people or animal to enter the area, the detector will switch on
or switch off. And it will send the external alarm signal into the IP camera.
Output Pins
Alarm power
Alarm
Switch