Installation Instructions

ARL02754U1 AC750 Wireless Dual Band Gigabit Router
- 18 -
network. The default SSID is set to be Wireless_2.4GHz_XXXXXX. This value is case-
sensitive. For example, TEST is NOT the same as test.
 Region - Select your region from the drop-down list. This field specifies the region where
the wireless function of the router can be used. It may be illegal to use the wireless function
of the router in a region other than one of those specified in this field. If your country or
region is not listed, please contact your local government agency for assistance.
 Note:
Limited by local law regulations, version for North America does not have region selection
option.
 Security
 Enable Security (WPA-PSK/WPA2-PSK) – It’s selected by default, with the default
PSK password the same as the default PIN code.
 Disable Wireless Security - The wireless security function can be enabled or
disabled. If disabled, the wireless stations will be able to connect the router without
encryption.
The above settings are only for basic wireless parameters. For advanced settings, please
check “More Advanced Wireless Settings”, and then you can set the following parameters.
 Band - This field displayed the operating frequency being configured.
 Mode - This field determines the wireless mode which the router works on.
 11bg mixed - Select if you are using both 802.11b and 802.11g wireless clients.
 11bgn mixed - Select if you are using a mix of 802.11b, 11g, and 11n wireless clients.
 Channel Width - Select any channel width from the drop-down list. The default setting is
“Auto”, which can adjust the channel width for your clients automatically.
 Channel - This field determines which operating frequency will be used. It is not necessary
to change the wireless channel unless you notice interference problems with another
nearby access point. If you select “Auto”, then the AP will select the best channel
automatically.
7. Configure the basic parameters for 5GHz wireless network in the following screen as shown in
Figure 3-14, and then click Next.