User's Manual

Nexxt Solutions – Wireless-N 3G router
23
You will see the following screen when the new device successfully connected to the net-
work.
Note:
3.6 Network
3.6.1 Internet access (Viking 150 only)
c.
Figure 3-13 Add a new device
Figure 3-14 Polaris 150 Figure 3-15 Viking 150
The status LED on the router will remain orange all the time if the device has been
successfully added to the network (Viking 150 only).
The WPS function cannot be configured if the Wireless Function of the router is disabled.
Please make sure the Wireless Function is enabled before configuring the WPS.
As shown in Figure 3-14, there are several submenus under the Network setting (depending
on the operation mode). Internet Access (Viking 150 ONLY), 3G, MAC Clone, WAN (seen in
Wireless Router Mode), MAC Clone (Viking 150 ONLY) and LAN. Click on any of these items
in order to configure the corresponding function.
Go to Network Internet Access in the menu in order to configure the 3G access mode as
shown on the screen below. The router is designed to work with either WAN port or 3G USB
modem, and supports automatic 3G switching if Ethernet WAN failover.
1.
2.