User's Manual

Nexxt Solutions - SAROS - Wireless N PCI-E Adapter
6
Chapter 2
Installation guide
2.1 Hardware Installation
2.2 Low-profile bracket installation
The installation guide will guide you through the installation process of the Saros -300 Wireless N
PCI-E Adapter, including basic hardware and software configuration.
Turn off your desktop PC and disconnect the AC power cable.
As soon as you remove the cover of your PC, locate an available PCI-E slot on the
motherboard. Remove the metal slot cover on the back of the PC. Should you need further
instructions, consult with your computer manufacturer.
If you want to install the low-prole bracket (Small Form Factor, SFF), use a Phillips screwdriver
to unfasten the two screws located above the PCB.
After removing the standard plate, replace the mounting screws to attach the low-profile
bracket to the PCB.
Slide the PCI adapter into the PCI-E slot. Make sure that all of its pins are touching the slot’s
contacts. Once the adapter is firmly in place, secure it to your PC’s chassis with the mounting
screw. Then, close your PC case.
Reconnect the AC power cable and turn your PC back on.
Note:
If the Found New Hardware Wizard system dialogue appears, select Cancel and use the
supplied Setup Wizard software CD for fast installation.
1.
2.
1.
2.
3.
4.