Warranty

Power DC-IN: Connect the supplied power adapter to this jack..

WAN port: This RJ45 port is where you will connect the DSL/ca-

ble modem or ethernet line from your ISP.

LAN port 1/2: Connect your local laptop or desktop computers in

your network to any of these RJ45 ethernet ports.

IPTV/LAN port 3: This is a LAN port by default. When the IPTV

feature on the router is enabled, this port can be used for connec-

ting an Internet Protocol receiver to stream videos on your TV set

via a set-top box.

WPS/RST button: Press and hold this button for about 8 seconds

until all LEDs light up once, and then release it to restore the device

to its factory default values.

Press and hold for a second to use the WPS feature (if enabled). To

successfully establish a WPS link, within the first 2 minutes the

wireless client’s WPS feature must be enabled.

Antennas: It is equipped with four dual-band omnidirectional

antennas.

First determine the optimum location for the router. The best place

is usually at the center of your wireless network with the antennas in

the upright position.

Then, connect the modem to the internet port of the router using

the supplied ethernet cable.

Connect your PC to the router if using a wired connection.

Insert one end of the supplied power adapter to the AC input jack

located on the rear panel of the router, before plugging the other

end to a standard electrical wall outlet.

3. Hardware installation

Open a web browser to access the main web interface. Type

http://www.nexxtwifi.local or 192.168.0.1 in the address bar

and press Enter on the keyboard.

The Quick setup wizard will come up to assist you in completing the

internet settings. Click on Start to initiate the process.

4. Router configuration

Select your connection type and click on Next. For the purposes of

this guide, the DHCP option was selected.

In this screen, you can set up the Transmit power, SSID and

Password. Once you finished configuring these settings, click on

Next to continue.