Instructions for Use
Table Of Contents
- Content
- [Customer]
- [Instructions for use]
- [Installation]
- 1.Installation Steps
- 1>How to find the power cord of the car ?
- 2>How to find the ground wire of the car (negative
- 3>How to find the horn line of the car?
- 4>How to test whether the unit work properly?
- 5>How to connect Bluetooth?
- 6>How to fix the unit ?
- 7>How to install the navigation antenna ?
- 8>The default factory mode password
- 9>The default Bluetooth Pin Code
- 2.Schematic diagram of reversing camera wiring
- 3.Fixed machine
- 1.Installation Steps
- [Introduction to basic functions]
- [Simple Trouble shooting]
- 1>Unable to boot normally
- 2> Automatic shut-down
- 3> Having noise
- 4> Remote control cannot be used
- 5> Settings con not be saved (no memory)
- 6> Car audio with Bluetooth but if can't work
- 7>The product smoke has proved that the internal c
- 8>How to adjust the sound, where is the equalizer
- 9>Support no image of reversing camera
- 10> USB flash disk can not be played, the card wit
- 11> FM does not receive the program
- 12>How to install
- 13>How to remove the original car's radio
- 14>Install it without reading the card or USB flas
- 15> Just installed no sound
- 16> After a while there is no sound
- 17>Machine reset
- 18>The other party cannot hear the voice of the Bl
- 19>The clock is still displayed after the product
44
- Check the phone to see if you can search for the unit code or no.
Operation steps: turn on the unit, use the phone Bluetooth search, search
for CAR-MP5,then click the connection, after connecting, you can answer the
phone or Bluetooth to play the song.
PIN Code: 0000 /1234.
7>The product smoke has proved that the internal
circuit has been burned and change the insurance FUSE
can not solve the problem
- In this case, the unit needs to be repaired.
8>How to adjust the sound, where is the equalizer set,
the sound can not be adjusted
-Adjust the sound: please turn the volume to adjust.
-Equalizer settings: In general, press the volume knob to display the
equalizer SEL, and rotate the volume button to adjust each sound effect.
-The sound cannot be adjusted: 1.Please reset the unit or unplug the
power cord and plug it in. 2.The Volume knob is broken, and the knob can
be replaced.
9>Support no image of reversing camera
-Generally two situations
1.Connect the wrong line or less wiring. Camera connection method:
a>The first step is to find accessories (accessory: one camera+ one
power cord+ one video cable).
b>The second step is to find the port of the wiring.First find the
reversing control line on the power line of the unit. The control line is a pink
line or brown line, connect this line to the positive pole of 12V and the
screen will turn blue. Find the back of the unit the CAME video input
interface, find the positive and negative of the backup light.
C>The third step is to connect: there are two sockets on the camera, the
red socket is connected to the power cable, the yellow is inserted into the