Instructions for Use
Table Of Contents
- Content
- [Customer]
- [Instructions for use]
- [Installation]
- 1.Installation Steps
- 1>How to find the power cord of the car ?
- 2>How to find the ground wire of the car (negative
- 3>How to find the horn line of the car?
- 4>How to test whether the unit work properly?
- 5>How to connect Bluetooth?
- 6>How to fix the unit ?
- 7>How to install the navigation antenna ?
- 8>The default factory mode password
- 9>The default Bluetooth Pin Code
- 2.Schematic diagram of reversing camera wiring
- 3.Fixed machine
- 1.Installation Steps
- [Introduction to basic functions]
- [Simple Trouble shooting]
- 1>Unable to boot normally
- 2> Automatic shut-down
- 3> Having noise
- 4> Remote control cannot be used
- 5> Settings con not be saved (no memory)
- 6> Car audio with Bluetooth but if can't work
- 7>The product smoke has proved that the internal c
- 8>How to adjust the sound, where is the equalizer
- 9>Support no image of reversing camera
- 10> USB flash disk can not be played, the card wit
- 11> FM does not receive the program
- 12>How to install
- 13>How to remove the original car's radio
- 14>Install it without reading the card or USB flas
- 15> Just installed no sound
- 16> After a while there is no sound
- 17>Machine reset
- 18>The other party cannot hear the voice of the Bl
- 19>The clock is still displayed after the product
18
3>Large text: Turn on this switch to make the font displayed on the
screen larger.
4>High contrast text: Users can turn on or turn off this operation.
5>Touch & hold delay: Users can choose three modes: Short, Medium,
Long.
6>Quick boot: Users can turn on or turn off this operation.
7>Color inversion: If turn on this switch, the background of the screen
will turn black.
8>Color correction: Users can turn on or turn off this operation.
20.About vehicular platform: Display important information such as the
system and version of the machine.
21.About the vehicle platform: Display important information, such as the
machine's system and version.
[GPS detection]
It is used to display the number of satellites currently positioned by GPS,
the signal strength of the positioned satellites, and other information of the
satellites.