Instructions for Use
Table Of Contents
- Content
- [Customer]
- [Instructions for use]
- [Installation]
- 1.Installation Steps
- 1>How to find the power cord of the car ?
- 2>How to find the ground wire of the car (negative
- 3>How to find the horn line of the car?
- 4>How to test whether the unit work properly?
- 5>How to connect Bluetooth?
- 6>How to fix the unit ?
- 7>How to install the navigation antenna ?
- 8>The default factory mode password
- 9>The default Bluetooth Pin Code
- 2.Schematic diagram of reversing camera wiring
- 3.Fixed machine
- 1.Installation Steps
- [Introduction to basic functions]
- [Simple Trouble shooting]
- 1>Unable to boot normally
- 2> Automatic shut-down
- 3> Having noise
- 4> Remote control cannot be used
- 5> Settings con not be saved (no memory)
- 6> Car audio with Bluetooth but if can't work
- 7>The product smoke has proved that the internal c
- 8>How to adjust the sound, where is the equalizer
- 9>Support no image of reversing camera
- 10> USB flash disk can not be played, the card wit
- 11> FM does not receive the program
- 12>How to install
- 13>How to remove the original car's radio
- 14>Install it without reading the card or USB flas
- 15> Just installed no sound
- 16> After a while there is no sound
- 17>Machine reset
- 18>The other party cannot hear the voice of the Bl
- 19>The clock is still displayed after the product
23
3
1
[Logo setting]
1.Logo Set: The user can set the car logo displayed when the machine is
turned on. The user can select from the pictures preset by the system, or
select from user uploaded pictures.
2.Animation: The user can set the animation when the machine is turned
on. The user can select from the animation preset by the system, or select
from user uploaded animation.
[Other settings]