Instructions for Use
Table Of Contents
- Content
- [Customer]
- [Instructions for use]
- [Installation]
- 1.Installation Steps
- 1>How to find the power cord of the car ?
- 2>How to find the ground wire of the car (negative
- 3>How to find the horn line of the car?
- 4>How to test whether the unit work properly?
- 5>How to connect Bluetooth?
- 6>How to fix the unit ?
- 7>How to install the navigation antenna ?
- 8>The default factory mode password
- 9>The default Bluetooth Pin Code
- 2.Schematic diagram of reversing camera wiring
- 3.Fixed machine
- 1.Installation Steps
- [Introduction to basic functions]
- [Simple Trouble shooting]
- 1>Unable to boot normally
- 2> Automatic shut-down
- 3> Having noise
- 4> Remote control cannot be used
- 5> Settings con not be saved (no memory)
- 6> Car audio with Bluetooth but if can't work
- 7>The product smoke has proved that the internal c
- 8>How to adjust the sound, where is the equalizer
- 9>Support no image of reversing camera
- 10> USB flash disk can not be played, the card wit
- 11> FM does not receive the program
- 12>How to install
- 13>How to remove the original car's radio
- 14>Install it without reading the card or USB flas
- 15> Just installed no sound
- 16> After a while there is no sound
- 17>Machine reset
- 18>The other party cannot hear the voice of the Bl
- 19>The clock is still displayed after the product
33
[TIMA]
1.Touch to exit the program.
2.Touch to switch the screen to the Android USB mobile phone
interconnection interface
3.Touch to switch the screen to the Android wireless mobile phone
interconnection interface.
4.Touch to switch the screen to the Apple wireless mobile phone
interconnection interface.
5.Touch to display information about the software.
6.Click to enter the file transfer interface.
7.Tap to open the QR code, and then scan the QR code on the phone to
download the TIMA APP.
[ANDROIDLINK menu]
Use a USB cable to connect to your mobile phone, or mobile hot
spot/WiFi (Android phone required)
Open the developer option on the phone, enter the developer option,
and then turn on USB debugging.