Instructions for Use

43
-Automatic shutdown usually has these following conditions
1.The cable error connect:If the blue cable (automatic antenna power
supply) is connected to the power cable of the unit, an automatic shutdown
will occur. Please follow the correct wiring method to solve the problem.
2.The voltage is unstable: please find a 12V-5A which one is the power
supply and re-tested to see if it will automatically shut down or no. If it does
not automatically shut down after the test, please replace the power supply.
If it will automatically shut down, it is problem with the unit.
3> Having noise
-The general situation of noise is caused by two reasons
1.The original speaker power is too small. When the volume of the unit is
turned up,there will be noise.
Solution: When replacing the speaker or listening to the song, the
volume should not be too large.
2. The speaker cable is grounded.
Solution: Take the iron speaker cable. Directly connected to the speaker
cable of the unit.
4> Remote control cannot be used
-Check if the battery of the remote control has power
Test method: Turn on the camera of the mobile phone and align the
light of the remote control, then press the button of the remote control to
see if the phone will light up. If it is not lit, there will be no power. Replace
the battery; That is, there is electricity, which proves that there is no problem
with the remote control.
5> Settings con not be saved (no memory)
- There is no memory function, there is only 2 points in memory
1.The yellow line and the red line are connected together (separate
yellow to positive, red to key control)
2.Yellow and red are reversed Gust change position)
6> Car audio with Bluetooth but if can't work